Most of the time, businesses will spend a lot of money to buy their lift trucks. It is important, therefore to take good care of your machinery to protect your investment into the long run. It is really a great idea to know the procedures that are undertaken in the care and maintenance of this piece of machinery.
One of the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it works. For instance, if there are any misses or knocks, the machine is defective and this should raise some issues. In addition listen closely for any squealing noise which come from the belts as these sounds would provide you with a lot of information.
Several of the main parts needing attention during maintenance comprise the gauges, horn, safety warning devices, the lights and the overhead guard. Any burnt out light bulbs or faulty parts should be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above parts have been inspected carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each cell of the battery needs to be checked so as to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The fuel filters, hydraulic filter and the transmission filter have to be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
Once the oil change has been carried out and new filters have been fitted, visually check the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Inspect the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. Then, inspect each and every other part of the machinery including the wheels. If any type of fault or concern is detected, be certain to address it immediately in order to make certain the machinery is running at its safest and optimum levels.